Trouble Shooting for the 7 Function Remote:

Answer the questions listed below and follow
the instructions to solve your problem.

Question	Answer
1. Does the fuse blow as soon as you power the receiver?	YES Try solution number 3.	NO Go to question number 2.
2. Does your remote operate sporadically or not at all?	SPORADIC Go to question number 3.	NOT AT ALL Skip to question number 4.
3. Does the remote work only when you are close to the car?	YES Try solution number 1.	NO go to question number 4.
4. Does the transmitter indicator light up green when you push the green button, red when you push the red button, and yellow when you push the yellow button?	YES Go to question number 5.	NO Try solution number 2.
5. Can you hear a clicking sound from the relays when you try to operate the remote?	YES Try solution number 3.	NO Go to question number 6.
6. If you unplug the orange pigtail and plug it back in, does the red LED indicator come on for about 5 seconds and go out.	YES Try solution number 4.	NO Try solution number 5.

Problem Definitions & Solutions

1. You are having a range problem. Try moving the antenna to a better location. Make sure it is not wrapped around anything steel. You might also try new batteries in the transmitter if it is more than a year old.

2. Your problem is in the transmitter. If only one or two buttons fails to light up, the problem is not the batteries. You will have to call for a replacement. If all three buttons fail to light, it is probably the batteries. Call if batteries do not correct the problem.

3. The problem is probably not in the remote. Make sure you have a good ground going to the receiver. Check your wiring. Post 86 & 87 should have 12+V on all relays. Also make sure your power window switches are wired exactly how the diagram show. You can get diagrams by clicking here. Specialty window switches work the same as GM.

4. Your transmitter probably needs re-coded. Click here for coding instructions. Also check your ground wires on the actuators and the receiver.

5. If the red LED stays on all the time when the unit is powered up, the receiver is shorted and must be replaced. If it fails to light at all, you have a bad ground or the unit is shorted.