3 Function Coding Instructions

 

STEP ONE
Begin the Coding Process by disconnecting the black ground wire from the receiver. Wait 10 seconds, and reconnect the ground. Within 7 seconds, press the code button. This will cause the red LED indicator to flash 2 or 3 times. This is the only time in the coding process that you will press the code button.

 

STEP TWO
Immediately pick up a transmitter and HOLD DOWN the green button. This will cause the transmitter indicator to light up green. The red & yellow buttons will be coded through the green button.

 

STEP THREE
Release the green button when the red LED indicator flashes one time. This tells you that the transmitter is coded. The job is done if you have one transmitter. Additional transmitters must be coded immediately following the first.

STEP FOUR
Immediately after releasing the green button on the first transmitter, pick up the next transmitter. Hold down the green button on this transmitter until the red LED indicator flashes one time. Repeat this step until all transmitters are coded.